Preventative Water Heater Maintenance in 10 Minutes

Posted by on Sep 24, 2014 in Water Heater Repair Athens GA

Water heater maintenance in ten minutes? Yes, that is correct. Water Heater Repair Athens GA is going to show one how to do some water heater preventative maintenance. And, that’s all it will take to do these 2 important water heater upkeep steps; nevertheless, we know that these will do an exceptional task of assisting with three things:

  • Having the water heater last as long as possible for it will save on cash with using it.
  • Ensuring a water heater runs safely is vital for we do not want it to blow up in in ones house.
  • And having it run more energy efficiently also helps one conserve one some money.

We are now prepared to invest 10 minutes once or twice a year to help save some money on energy costs.

Testing the T&P Relief Valve
The T&P Valve, also referred to as the temperature and pressure relief valve, has an important task. It’s role is to help make sure excess pressure inside the water tank does not build up, or in even more simple terms, it sees to it that the water heater does not explode. The T&P valve is the part that has a lever or little handle. Simply lift it some then let go of it back. It should snap back to its closed position rapidly. A little water should be heard entering into the drain pipe below the lever that was just raised and maybe heard some pressure being released at the same time. If none of these things have actually occurred throughout the test, the valve will require to be changed.

Do a Mini Water Heater Tank Flush
Naturally, rust and corrosion will occur inside the water tank due to the chemical reactions taking place with all the parts inside that are required to heat water. We will not get too technical here, however it is easy to help prevent this process by doing a flush or draining of all or a portion of the water in the tank.

For simply a small flush, position a container under the drain valve below the tank. Open the drain valve and fill up the pail with water. Drain at least a few gallons of water in all. Let the water sit in the bucket for a couple of minutes to settle and analyze if there is much that settles to the bottom of the pail. If there is, if the water heater has actually not been drained for a very long time (or ever), it would be best to do a full flush of the tank to get as much of the sediment out as possible. You will want to turn the temperature dial down and might want to let the water cool down for about an hour first so it is not too hot while draining it. Likewise, it would be simpler to connect a hose to the drain valve and let the water go outside instead of using buckets.

If the water looks reasonably clean and clear from the tiny test you should be all set. When the water heater has a large quantity of sediment inside of it, it can make loud popping noises and it reduces its effectiveness too.

Though water heaters are relatively upkeep free and simple to run, any time one feels the smallest uncomfortable or are uncertain of exactly what to do, it is always best to have give Water Heater Repair Athens a call to assist with ones regular water heater maintenance.

Here is an infographic that illustrates these steps, and check out our blog more water heater tips and advice.

Water Heater Repair Athens GA